Analysis of the angles in hip, knee and ankle during the pedaling of a Cross Country Olympic cyclist

Luis M. Aguilar, Juan P. Torres, Christian R. Jimenes, Diego R. Cabrera, Miguel F. Cardenas, Patricio F. Urgirles

Producción científica: Contribución a una conferenciaDocumento

5 Citas (Scopus)

Resumen

© 2015 IEEE. This paper shows the analysis of the angles in the hip, knee and ankle. In a complete cycle of pedaling, are obtained the superior values, following a protocol totally specified in the document. Through the use of an acquisition software, named Kinovea®. The data of each one of the angles are set; in this manner the data information can be exported to Matlab®. In Matlab® Software the analysis of the results is performed with each one of the test subjects. With the obtained results, the analysis is performed with the correlation factor. The correlation factors obtained in the hip and knee are greater than 0.75, meanwhile the values obtained in the ankle are oscillating between 0.2 and 0.4. All this analysis was performed with the patron subject as a reference. The patron subject is a cyclist who has national and international championships.
Idioma originalInglés
Páginas205-208
Número de páginas4
DOI
EstadoPublicada - 4 feb. 2016
Evento2015 IEEE Chilean Conference on Electrical, Electronics Engineering, Information and Communication Technologies, CHILECON 2015 - Santiago, Chile
Duración: 28 oct. 201530 oct. 2015

Conferencia

Conferencia2015 IEEE Chilean Conference on Electrical, Electronics Engineering, Information and Communication Technologies, CHILECON 2015
Título abreviadoCHILECON 2015
País/TerritorioChile
CiudadSantiago
Período28/10/1530/10/15

Huella

Profundice en los temas de investigación de 'Analysis of the angles in hip, knee and ankle during the pedaling of a Cross Country Olympic cyclist'. En conjunto forman una huella única.

Citar esto